Accessories for Micro-inverter Enphase

Connector's hood for IQ Enphase micro-inverter. 

This tool allows you to disconnect your IQ Enphase micro-inverter from its connector. It can also be used to tighten the tip termination.

This product is very useful for mounting all Enphase products. 

Female connector for IQ Enphase micro-inverter. 

Male connector for IQ Enphase micro-inverter. 

This tip of ending is completely sealed and waterproof. Be careful when you attach this piece to your IQ Enphase cable: you can only remove it by cutting. Make sure you order the right cable length.

Proper installation with our Enphase products. 

The connectors are located 1.3m apart from eachother in portrait mode. The quantity you select refers to the number of connectors. The connectors are already mounted on the cable. Of course this number is linked to the number of Enphase micro-inverters you have ordered.

This solution is ready to use.

Length 1.3 meters
Three-phase

The connectors are located 2m apart from eachother in portrait mode. The quantity you select refers to the number of connectors. The connectors are already mounted on the cable. Of course this number is linked to the number of Enphase micro-inverters you have ordered.

This solution is ready to use.

Length 2.3 meters
Three-phase

Add ENPHASE current transformers to monitor a polyphase or three-phase installation with the ENVOY-S Metered.

External Relay for IQ7 In Enphase installations, the Q Relay (Network System Relay Controller) acts as a physical disconnect relay controller for installations.

The Enphase COMMS kit is required to establish the data connection between the IQ-5P Encharge storage units and the Enphase Envoy. The data connection runs via Zigbee. It is connected to the Envoy via USB.